How to add GPS Connection

How to add external GPS Connection

1. Add GPS module directly to ESP32DR GND,GPIO16,3.3V pin
2. Configuration [UARTx Modify] table Enable, RX GPIO: 16, TX GPIO: if not use set to -1 and press Apply.
3. Configuration [GNSS Modify] table Enable, PORT:x UART same select by No.2 and press Apply.
4. RESET by hardware or off/on power plug
5. Recheck config and monitor GPS dashboard.

You can see monitor GNSS by Clik [View] on the GNSS Info at dashboard.